Blind Spot Sensor - Installation

INSTALLATION






NOTE: The sensor brackets are bonded to and integral to the back side of the rear bumper fascia.

1. Align and insert the sensor (6) into the sensor bracket on the back of the rear bumper fascia (2) until the bracket latch features are fully engaged over the top and bottom latch tabs of the sensor.
2. From the back of the fascia, reconnect the wire harness connector (5) to the sensor connector receptacle.
3. Install the bumper fascia onto the rear of the vehicle. Rear Bumper Fascia - Installation.
4. Connect the negative battery cable.