Rear

REAR

NOTE: The park assist sensors, the sensor spacers and the sensor brackets are each available for separate service replacement. The following service procedure can be used for disassembling any or all of these components from the rear bumper fascia.





1. Disconnect and isolate the battery negative cable.
2. From the back of the fascia, disconnect the wire harness connector from the park assist sensor connector receptacle (1).
3. Carefully pry the sensor bracket latch features (2) away from the top and bottom tabs of the sensor far enough to disengage the sensor from the bracket.





4. Separate the sensor spacer (2) from the sensor.