Differential

REMOVAL

Special Tools:










1. Remove the exhaust as necessary to obtain clearance while lower the rear differential. Exhaust Tailpipe/Resonator - Removal
2. Remove the rear differential as necessary to gain enough access to the differential support isolators. Removal
3. Position transmission jack (1) to rear axle assembly.





4. Remove rear axle forward mount isolator bolt/nut (1).





5. Remove the bolts (1) and lower the stabilizer bar (2).





6. Remove two rear axle-to-crossmember bolts (1).
7. Lower axle just enough to gain access to the differential isolator being serviced.










NOTE: Prior to using special tools, lubricate Screw Assembly (3) threads to provide ease of use and promote tool longevity.

NOTE: When installing thrust bearing, be sure to place hardened side toward bolt head.

8. Assemble tools over isolator as shown.
9. While holding Nut from rotating, using hand tools, tighten Screw Assembly (3) until Remover/Installer (5) comes in contact with isolator and Remover/Installer, Bushing (2) sets squarely against crossmember (4).
10. Continue to tighten Screw Assembly (3), pressing isolator out of crossmember (4).
11. Remove tools with isolator.