Upper

INSTALLATION





1. Position the seat belt through the hole in the trim.
2. Position the upper B-pillar trim panel (1) to the B-pillar and engage the upper retaining tabs (1) that secure the trim panel to the B-pillar.
3. Seat the lower clips (2) fully.
4. Install the lower B-pillar trim. B-Pillar Trim Panel - Installation





5. Position the seat belt lower anchor (3) to the mounting hole on the outboard side of the front seat cushion frame. Be certain that the seat belt webbing between the turning loop and the lower anchor is not twisted.
6. Install and tighten the screw (1) that secures the lower anchor to the seat. Tighten the screw to 54 Nm (40 ft. lbs.).
7. Install the lower anchor cover (2) onto the front seat cushion outboard side shield (4) by seating the integral lower tab of the cover into position, then pushing inward using care to avoid breaking any of the cover tabs.