Disc Brake Caliper Adapter - Installation

INSTALLATION

NOTE: Front caliper adapter shown, rear caliper adapter similar.





1. Position the brake caliper adapter (4), install the brake caliper adapter mounting bolts (1) and tighten to:
a. Front - 200 Nm (148 ft. lbs.)
b. Rear - 120 Nm (89 ft. lbs.)

NOTE: Brake caliper slide bolts (guide pins) (2) should be free from debris.

2. Position the brake caliper (3), install the brake caliper slide bolts (guide pins) (2) and tighten to:
a. Front - 55 Nm (41 ft. lbs.)
b. Rear - 27.5 Nm (20 ft. lbs.)
3. Install the caliper slide dust bolt shields.





4. Install the brake caliper tension clip (1).
5. Install the tire and wheel assembly. Service and Repair.
6. Pump brake pedal until caliper pistons and brake pads are seated and a firm brake pedal is obtained.