Brake Backing Plate - Installation

INSTALLATION






NOTE: A new backing plate assembly will have a plastic spacer to hold the park brake actuating lever in position to attach the brake cable. Do not remove the plastic spacer until the brake cable is attached to the lever.

1. Spread the shoes to fit over the stops and position the backing plate assembly (1) on the knuckle.
2. Install the backing plate bolts (2) and tighten to 13 Nm (116 in. lbs.).

NOTE: Remove the park brake lever spacer from this location (3) after attaching the brake cable, and before installing the rotor or adjusting the shoes.

3. Install the hub/bearing and knuckle Rear Hub And Bearing - Installation
4. Adjust brake shoes Adjustments
5. Install the wheel and tire assembly Service and Repair.

6. Remove the support and lower the vehicle.