Front Air Inlet Housing

HOUSING-AIR INLET





1. Position the recirculation-air door (1) onto the pivot shaft (2) located on the right half of the air inlet housing (3).






CAUTION: Make sure that the recirculation door pivot shaft is properly located in the shaft opening on the left half on the air inlet housing.

2. Install the two halves of the air inlet housing (2 and 4) together. Be sure to properly align the recirculation door pivot shaft with the opening on the left side of the air inlet housing
3. Install the seven screws (3) that secure the two halves of the air inlet housing together. Tighten the screws to 2 Nm (17 in. lbs.).





4. Install the recirculation door actuator (1) onto the air inlet housing (3). If necessary, rotate the actuator slightly to align the splines of the actuator output shaft (4) with those on the recirculation door pivot shaft (2).





5. Install the two screws (1) that secure the recirculation door actuator (2) to the air inlet housing (3). Tighten the screws to 2 Nm (17 in. lbs.).
6. If equipped, install the particulate air filter into the opening in the air inlet housing with the arrow on the filter pointing down and install the cover (4). Make sure the retaining tab (5) is fully engaged Particulate Air Filter - Installation.
7. Install the air inlet housing onto the HVAC housing HVAC Housing - Installation.