Rear Suspension Toe Link - Installation

INSTALLATION






NOTE: The toe link must be installed below the stabilizer bar.

1. Using a suitable holding fixture, support the outboard end of the lower control arm and lift it to normal ride height.
2. Position the toe link (4) and install the toe link to knuckle bolt/nut (1) and tighten to 108 Nm (79 ft. lbs.).

NOTE: Position the cam as close to removal marking as possible to aid in alignment.

3. Install the toe link to cradle cam bolt/nut (3) and tighten to 93 Nm (68 ft. lbs.).
4. Connect the parking brake clip to the toe link (4).
5. Install the stabilizer bar to cradle bolts (4) and tighten to 110 Nm (81 ft. lbs.).
6. Remove the lower control arm holding fixture.
7. Install the tire and wheel Service and Repair.
8. Remove the supports and lower the vehicle.
9. Perform an alignment Wheel Alignment Procedures