Differential

INSTALLATION

Special Tools:















NOTE: Prior to using special tools, lubricate Screw Assembly (1) threads to provide ease of use and promote tool longevity.

NOTE: When installing thrust bearing, be sure to place hardened side toward bolt head.

NOTE: A mixture of soap and water may be used to aid installation of the isolator.

1. Assemble tools over isolator as shown.
2. While holding Nut (4) from rotating, tighten Screw Assembly (1) using hand tools, pressing isolator (2) into crossmember (4). Stop when the isolator (2) bottoms against Remover/Installer, Bushing.
3. Remove tools.





4. Carefully raise rear axle.
5. Install two rear axle-to-crossmember bolts (1) and torque to 135 Nm (100 ft. lbs.).





6. Install rear axle forward mount isolator bolt/nut (1) and torque to 135 Nm (100 ft. lbs.).





7. Position the stabilizer bar (2) and install the upper and lower stabilizer bar to cradle bolts (1) and tighten to 110 Nm (81 ft. lbs.).
8. Install the exhaust if necessary. Exhaust Tailpipe/Resonator - Installation