Brake Rotor - Installation

INSTALLATION

NOTE: Front rotor shown, rear rotor similar.





1. Install the rotor (1) on wheel studs.





2. Position the brake caliper adapter (4), install the brake caliper adapter mounting bolts (1) and tighten to:
a. Front - 200 Nm (148 ft. lbs.)
b. Rear - 120 Nm (89 ft. lbs.)

NOTE: Caliper slide pins should be free from debris.

3. Position the brake caliper/pads and tighten the brake caliper slide bolts (guide pins) (2) to:
a. Front - 55 Nm (41 ft. lbs.)
b. Rear - 27.5 Nm (20 ft. lbs.)
4. Install the caliper slide bolt dust shields.





5. Install the brake caliper tension clip (1).
6. Install the tire and wheel assembly Service and Repair.
7. Remove the supports and lower the vehicle.
8. Pump brake pedal until caliper pistons and brake pads are seated and a firm brake pedal is obtained.