Flexible Hose

FLEXIBLE HOSE

NOTE: Front flexible brake hose shown, rear similar.





1. Position the flexible brake hose (2) through the bracket and install the retaining clip (3).
2. Tighten the solid brake line fitting (1) to 19 Nm (168 in. lbs.).





3. Install new washers, and the banjo bolt through the line and into the caliper. Tighten the banjo bolt to 30 Nm (22 ft. lbs.).
4. If equipped, connect the wheel speed sensor wiring routing clip (1) to the flexible brake hose (2).
5. If installing the rear flexible brake hose, install the tire and wheel assembly Service and Repair.
6. Remove the supports and lower the vehicle.
7. Remove the prop rod from the brake pedal.
8. Bleed the area of repair for the brake system, if a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performedService and Repair.