Front Hub And Bearing - Installation

4X4





1. Position the hub/bearing, install the hub/bearing bolts (2) and tighten to 105 Nm (78 ft. lbs.).





2. Support the outside of the lower control arm with a suitable holding fixture, and raise to position the upper ball joint (2) into the knuckle (3).
3. With the holding fixture holding the suspension at normal ride height, install the upper ball joint nut (4) and tighten to 95 Nm (70 ft. lbs.).
4. Install the half shaft nut and tighten to 310 Nm (229 ft. lbs.).
5. Install the brake rotor. Brake Rotor - Installation.





6. Route and attach speed sensor wiring to the knuckle.
7. Install the wheel speed sensor into the knuckle, install the mounting bolt (2) and tighten to 10.7 Nm (95 in. lbs.).
8. Position the stabilizer link (7) to lower control arm (8), install the nut and tighten to 122 Nm (90 ft. lbs.).
9. Install the tire and wheel assembly. Service and Repair.
10. Remove the supports and lower the vehicle.