Installation

INSTALLATION

WARNING: Do not smoke or use open flames/sparks when servicing the fuel system. Wear protective clothing and eye protection. Make sure the area in which the vehicle is being serviced is in a well ventilated area and free of flames/sparks. Failure to comply may result in serious or fatal injury.





The vapor canister is mounted to a V-Slot bracket and does not require any fasteners.

1. Position the vapor canister to the V-Slot (2) mounting bracket and slide the canister downward into the V-Slot until the retaining tab (1) clicks/locks in place.






NOTE: The vapor/vacuum lines must be firmly connected. Check the vapor/vacuum lines at the EVAP canister for damage or leaks. If a leak is present, a Diagnostic Trouble Code (DTC) may be set.

2. Connect the fuel tank vapor line (5) quick-connect fitting to the EVAP canister.
3. Connect the vapor purge line (4) quick-connect fitting to the EVAP canister.
4. Position the ESIM (3) to the EVAP canister and rotate clockwise about 70 degrees and lock in place.
5. Connect the electrical connector (2) at the ESIM.
6. Carefully install the ESIM fresh air hose (1) at the fresh air filter.





7. Install the left rear wheelhouse splash shield Splash Shield - Installation.
8. Install left rear wheel and tire.





9. Lower the vehicle.
10. Connect the negative battery cable (2).
11. Install the fuel tank filler cap.
12. Start the engine and check for leaks.