Rear Axle - 230RIA

FLUID DRAIN AND FILL

NOTE: The fluid required for use in this axle is Mopar(R) Gear and Axle Lubricant 75W-85.





1. Drive the vehicle until the differential lubricant is at the normal operating temperature.
2. With vehicle in neutral, position and raise vehicle on hoist.
3. Remove rear axle drain plug (1) and drain lubricant completely from the axle.
4. Install drain plug and tighten to 35 Nm (26 ft lbs).





5. Remove fill plug (1) and fill rear axle and insure axle is filled to the bottom of the fill hole.
6. Install fill plug and tighten to 35 Nm (26 ft lbs).