Rear Door Glass - Removal

REMOVAL





1. Remove the upper trim molding.

NOTE: There are foam seals at either end that is held in place by the inner belt molding. Carefully remove the seals along with the inner belt molding.

2. Separate the belt molding from the door mounting flange from the back to the front.





3. If necessary, temporarily connect the window switch assembly and battery to actuate the motor.
4. Position the glass to access the glass slider on the regulator through the access door (1).





5. Remove the plug (3) located near the motor.
6. Using the regulator, move the front door glass (1) up or down as required to access the two window regulator glass release tabs (2, 3) through the access holes in the regulator rails.






NOTE: Place a protective covering over the outer belt molding to prevent grease transfer to the molding and glass.

7. Using a small round bladed tool (2) or equivalent, release the door glass (1) from the window regulator glass sliders (3).






NOTE: Illustration shown with inner door panel removed for clarity.

8. Carefully rotate the door glass (1) towards the rear of the vehicle within the window opening.





9. Remove the glass (2) from the door, through the window opening (1).