Rear
REAR
1. From the outside of the liftgate, install a new rubber bezel and grommet (3) into the rear wiper motor output shaft clearance hole of the liftgate glass (4). Always use a new bezel and grommet in the glass.
2. From the inside of the liftgate, position the rear wiper motor output shaft and housing (2) through the bezel and grommet in the liftgate glass clearance hole.
3. Position the rear wiper motor mounting bracket to the liftgate inner panel.
4. Install and tighten the three screws (3) that secure the motor mounting bracket to the liftgate inner panel. Tighten the screws securely.
5. Reconnect the liftgate wire harness connector (4) to the rear wiper motor connector receptacle.
6. Reinstall the trim onto the liftgate inner panel. Liftgate Trim Panel - Installation.
7. From the outside of the liftgate, reinstall the rear wiper arm onto the motor output shaft. Wiper Arm - Installation
8. Reconnect the battery negative cable.