Power Sliding Door Module, Left (PSDML)

B210A-SYSTEM VOLTAGE LOW





For a complete wiring diagram, refer to the Wiring Information .

- When Monitored:
At all times.

- Set Condition:
When the TIPM sends a message to the Power Sliding Door Module that the vehicle voltage is below 10.0 volts for over 15 seconds, this code will set.





CHECK POWERTRAIN DTCs

NOTE: The most probable cause for this DTC in this module is that the charging system or battery has failed causing a low vehicle system voltage.

NOTE: Make sure the battery is fully charged and serviceable before proceeding.

1. With the scan tool, read POWERTRAIN DTCs.

Are there any Battery, Charging or Starting DTCs present?

Yes

- Perform the appropriate diagnostic procedure. Testing and Inspection.

No

- This code is for information only. At some time there was a low battery system voltage. Check the battery and charging system.
- Perform the BODY VERIFICATION TEST. Body Verification Test.