Third Row, Stow-n-Go

REMOVAL

Special Tools:











NOTE: 60% seat shown, 40% seat similar unless noted.

NOTE: On all leather trimmed seats, seat cushion cover can be removed from the foam pad. On cloth trimmed seats, the cushion cover does not separate from the foam pad.

1. Remove the affected seat from the vehicle, Seat - Removal.
2. Remove the fasteners (3) securing the rear shield (1).
3. Remove the rear shield (1) by pulling up on the bottom of the shield and rolling it upward.





4. Remove the fastener (2) from the front of the side shield (1). Repeat on the opposite side.





5. Remove the side shield (1). Repeat on the opposite side.





6. Tilt the seat back.
7. Remove the front leg shield (1). Repeat on the opposite side.
8. Using special tool,, remove the pull strap bezel (2).





9. Disengage the J-clips (1) located under both legs.





10. Unzip the seat cushion zipper (1) on both sides of the seat.





11. Using special tool, , disengage the retaining fasteners (1) securing the bottom of the seat cushion to the seat cushion pan.
12. Unzip both sides of the seat covers.
13. Remove the cover and foam from cushion pan panel.
14. If required, separate the seat cushion cover from the foam by disengaging the locking strips from the keepers.