Cylinder Head Assembly: Specifications

CYLINDER HEAD









Tighten the cylinder head bolts in the sequence shown, following this 9 step torque plus angle method. Tighten according to the following torque values:
Step 1: 30 Nm (22 Ft. lbs.)
Step 2: 45 Nm (33 Ft. lbs.)
Step 3: + 75° Turn Do not use a torque wrench for this step.
Step 4: + 50° Turn Do not use a torque wrench for this step.
Step 5: Loosen all fasteners in reverse of sequence shown
Step 6: 30 Nm (22 Ft. lbs.)
Step 7: 45 Nm (33 Ft. lbs.)
Step 8: + 70° Turn Do not use a torque wrench for this step.
Step 9: + 70° Turn Do not use a torque wrench for this step.

BOLT RE-USABILITY

The bolts must be examined BEFORE reuse. If the threads are necked down the bolts must be replaced.







CAMSHAFT BEARING CAP









Camshaft bearing caps and hand tighten the retaining bolts 2 Nm (18 in. lbs.)
Tighten the bearing cap retaining bolts 9.5 Nm (84 in. lbs.)

INTAKE MANIFOLD
Intake Manifold Specifications

CAMSHAFT GEAR/SPROCKET
Camshaft Gear/Sprocket Specifications