Chime Warning System

CHIME WARNING SYSTEM

DOOR AJAR CHIME

The Instrument Cluster (IC) (also known as the Common Instrument Cluster/CIC) will sound an audible chime when the key is in the ignition and the driver side front door is open. This provides an alert that a door is open or only partially closed.

The audible chime will sound when the vehicle begins to move and a visual alert appears within the transmission range indicator of the IC indicating DOOR.

ENHANCED SEAT BELT REMINDER

If all the following conditions are met after sixty seconds with the engine ON, then the enhanced seat belt reminder feature will be activated.

- Driver seat belt is unbuckled for ten seconds or more.
- Vehicle speed is greater than five mph (8 km/h).
- The transmission gear selector position is not REVERSE (except in MTX vehicles where the reverse position cannot be detected).

The seat belt indicator will periodically blink, accompanied by a continuous chime for approximately ninety-six seconds or until the driver seat belt is buckled. When the enhanced seat belt feature is not initiated or if the feature is disabled, the seat belt indicator will be turned ON continuously until the driver seat belt is buckled.

In the same ignition cycle, if the seat belt is again unbuckled for more than ten seconds with the vehicle speed greater than five mph (8 km/h), the enhanced seat belt reminder feature will again be initiated.

The enhanced seat belt reminder feature is customer programmable and can be enabled or disabled using a diagnostic scan tool, or by the customer completing a specific sequence of steps as follows:

1. With the ignition not in RUN or START, buckle the driver seat belt.
2. Turn the ignition switch to the RUN or START position and wait for the seat belt reminder check to be completed.
3. Unbuckle and then re-buckle the driver seat belt causing the indicator to go ON and OFF three or more times ending with the seat belt buckled.
4. Return the ignition switch to a non-RUN or non-START position. The feature will toggle from the current status and a confirmation chime will sound indicating to the customer that the proper sequence to enable or disable the feature has been successfully completed.

EXTERIOR LAMPS LEFT ON

An audible chime tone that indicates the exterior lamps were left ON.

FASTEN SEAT BELTS

At power up, the IC will conduct a seat belt lamp bulb check. If the driver side seat belt buckle is unbuckled during the bulb check, an accompanying chime will sound within the duration of the bulb check.

KEY LEFT IN IGNITION

An audible chime tone that indicates the key was left in ignition.

SINGLE WARNING CHIME

After a bulb check at power-up, if any of the following indicators are still activated, the IC will sound a single chime tone. ABS, Air Bag, Check Engine, Charging System, Engine Temperature, Low Fuel (after 10 seconds for accurate fuel information), and BRAKE (if speed is greater than 2 mph).