Instrument Panel Bezel - Installation

INSTALLATION






CAUTION: Do not disconnect/connect the ICSS/switch bank without referring to the appropriate procedure. The harness connector is very fragile and could be damaged if not properly removed/installed.

1. Position the center bezel (1) in place and align the spring retainers with the instrument panel.
2. Connect the integrated center stack screen, Integrated Center Stack Screen Module - Installation.
3. Hand tap center bezel (1) in place ensuring proper seat.






CAUTION: Do not disconnect/connect the ICSS/switch bank without referring to the appropriate procedure. The harness connector is very fragile and could be damaged if not properly removed/installed.

4. Position the switch-bank assembly in place.
5. Connect the electrical connector (2) to the back of the switch-bank assembly (1), Instrument Cluster Switch Pod - Installation





6. Position the switch-bank in the I/P and press evenly the engage the two lower clips (3).
7. Install, and tighten the two screws (2) that secure the switch-bank (1) to the I/P (4).





8. Install the instrument panel outlet vent/trim (1), Air Outlet - Installation.





9. Align and press firmly to install the instrument panel trim (1) located left of the center stack bezel.
10. Install the glove box.
11. Connect the negative battery cable.