Park Assist Display - Installation

INSTALLATION





1. Carefully position the connector receptacle on the left end of the park assist display housing (3) through the left end of the display opening in the lower surface of the headliner (5).
2. Slide the display toward the left side of the vehicle far enough to engage the right end of the display housing into the right end of the display opening in the headliner.
3. Carefully pull down the rear edge of the headliner from the upper liftgate opening header (2) far enough to access the rear park assist display housing.
4. With the display lens held flush against the lower surface of the headliner, position the molded plastic retainer (4) over the display housing with the installation tab oriented towards the rear of the vehicle.
5. Slide the retainer down over the display housing until it is flash with the headliner substrate and the three tabs of the retainer are engaged in the three slots of the display housing.
6. Reconnect the wire harness connector (1) to the connector receptacle on the left end of the display housing.
7. Reinstall the quarter trim panel onto both upper D-pillars. Quarter Trim Panel - Installation.
8. Reinstall the trim onto the upper liftgate opening. Header Panel - Installation.
9. Reconnect the battery negative cable.