Rear Tube / Hose Assembly - Heavy Duty

REAR TUBE / HOSE ASSEMBLY - HEAVY DUTY










1. Install the hose (3).
2. Install the banjo bolt (1) at the caliper and tighten fitting bolt to 27 Nm (245 in. lbs.).
3. Install the mounting bolt (2) for the brake hose (3) at the axle.
4. Install the brake line located at the axle.
5. Lower the vehicle and remove the support.
6. Remove the prop rod from the brake pedal.
7. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed.Service and Repair.