Engine Oil Pan - Installation

INSTALLATION

Special Tools:










1. Clean the oil pan gasket mating surface of the bedplate and oil pan.
2. Position the oil pan gasket and pickup tube with new o-ring. Install the mounting bolt and nuts. Tighten bolt and nuts to 28 Nm (20 ft. lbs.).
3. Position the oil pan and install the mounting bolts. Tighten the mounting bolts to 15 Nm (11 ft. lbs.) in the sequence shown.

4. Lower the engine into mounts using special tool.
5. Install both the left and right side engine mount through bolts. Tighten the nuts to 68 Nm (50 ft. lbs.).
6. Remove special tool.
7. Connect cooler lines to radiator, transmission and clips.

NOTE: When connecting the transmission oil cooler lines, it is necessary to replace the line clip that is located on the oil pan stud. The retention force of the clip is severely degraded upon removal.

8. Install structural dust cover, if equipped.
9. Install the front crossmember Crossmember - Installation.
10. Fill engine oil.
11. Reconnect the negative battery cable.
12. Start engine and check for leaks.