Operation CHARM: Car repair manuals for everyone.
Home >> Dodge and Ram >> 2011 >> RAM 2500 Truck 4WD L6-6.7L DSL Turbo >> Repair and Diagnosis >> Heating and Air Conditioning >> Refrigerant Pressure Sensor / Switch >> Service and Repair >> A/C Pressure Transducer - Installation
Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay $250), please get in contact with us ASAP: email operation-charm [[at]] tuta.io or click to submit anonymously

A/C Pressure Transducer - Installation






INSTALLATION

NOTE: Use only the specified O-ring as it is made of special material for R-134a. Use only refrigerant oil of the type required for the A/C compressor.






NOTE: Typical A/C pressure transducer and refrigerant line shown.

1. Lubricate a new rubber O-ring seal (4) with clean refrigerant oil and install it onto the discharge line fitting (3).
2. Install the A/C pressure transducer (2) onto the A/C discharge line. Tighten the A/C pressure transducer to 5.1 Nm (45 in. lbs.).
3. Connect the wire harness connector (1) to the A/C pressure transducer.
4. Reconnect the negative battery cable.

pro multis · About Operation CHARM