Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Sentry Key Immobilizer Module (SKREEM) - Removal






REMOVAL






NOTE: The steering wheel does not have to be removed to service the SKREEM/WCM.

NOTE: The Steering Column Control Module (SCCM) assembly, which consists of the left/right multi-function switches and the clockspring, does not have to be removed to service the SKREEM/WCM. There is an access hole in the top of the right multi-function switch to access the mounting screw (2).

1. Disconnect and isolate the battery negative cable.

WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service. Failure to do so may result in accidental airbag deployment, personal injury or death.

2. Remove the upper and lower steering column shrouds Steering Column Shroud - Removal and Steering Column Shroud - Removal.
3. Remove the SKREEM/WCM mounting screw (2) on the ignition lock assembly and separate the SKREEM/WCM (3) from the ignition lock assembly.





4. Disconnect the SKREEM/WCM electrical connector (4).
5. Remove SKREEM/WCM (1 and 3) from column (2).

When a PCM and the SKREEM/WCM are replaced at the same time, perform the following steps in order Testing and Inspection.

- Program the new PCM.
- Program the new SKREEM/WCM.
- Replace all ignition keys and program them to the new SKREEM/WCM.