C211B

C211B-92-IGNITION RUN/START INPUT CIRCUIT PERFORMANCE - PERFORMANCE OR INCORRECT OPERATION





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuous.

- Set Condition:
The Ignition Status reported on the CAN Bus does not match the state of the Ignition Input.





NOTE: If any other DTCs are present, repair them first before continuing with this diagnostic procedure.

1. VERIFY THE DTC IS ACTIVE

NOTE: This DTC must be active for the results of this test to be valid.

1. Turn the ignition on.
2. With the scan tool, read and record the DTCs.
3. With the scan tool, erase the DTCs.
4. Start the engine.
5. With the scan tool, read and record the DTCs.

Is the DTC active at this time?

Yes

- Go To 2

No

- Perform the ABS-INTERMITTENT CONDITION TEST. Testing and Inspection.

2. CHECK THE FUSE
1. Ignition on, engine not running.
2. Using a 12-volt test light connected to ground, check the fuse for power.

Is the fuse good?

Yes

- Go To 3

No

- If the related fuse is open, check the (F202) Fused Ignition Switch Output (RUN/START) circuit for a short to ground.
- Perform the ABS VERIFICATION TEST. ABS Verification Test.

3. (F202) FUSED IGNITION SWITCH OUTPUT (RUN-START) CIRCUIT SHORT TO VOLTAGE




1. Turn ignition off to the lock position.
2. Disconnect the ABS Module harness connector.
3. With a test light connected to ground check the (F202) Fused Ignition Switch Output (RUN/START) circuit at the ABS harness connector.

NOTE: The test light must illuminate brightly. Compare the brightness to that of a direct connection to the battery.

Does the test light illuminate brightly?

Yes

- Go To 4

No

- Repair the Power circuits for an open or high resistance.
- Perform the ABS VERIFICATION TEST. ABS Verification Test.

4. POWER CIRCUITS FOR AN OPEN OR HIGH RESISTANCE




1. Ignition on, engine not running.
2. With a test light connected to ground check (A107) Fused B+, (A111) Fused B+ and (F202) Fused Ignition Switch Output (RUN/START) circuits at the ABS harness connector.

NOTE: The test light must illuminate brightly. Compare the brightness to that of a direct connection to the battery.

Does the test light illuminate brightly?

Yes

- Replace the Anti-lock System Brake (ABS) Module. Anti-Lock Brake System Module - Removal.
- Perform the ABS VERIFICATION TEST. ABS Verification Test.

No

- Repair the Power circuits for an open or high resistance.
- Perform the ABS VERIFICATION TEST. ABS Verification Test.