U0208

U0208-LOST COMMUNICATION WITH HEATED SEAT CONTROL MODULE (HSM)

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the ignition on.

Battery voltage between 10 and 16 volts.

Ignition Off Draw (IOD) fused installed.

Totally Integrated Power Module (TIPM) is configured correctly.

- Set Condition:
Bus messages not received from the Heated Seat Module (HSM) for approximately two to five seconds.





Diagnostic Test

1. VERIFY DIAGNOSTIC TROUBLE CODE (DTC) IS ACTIVE

NOTE: Make sure the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding.

1. With the scan tool, read active DTCs.

Is this DTC active?

Yes
- Go To 2

No
- Stored Lost Communication DTCs and perform the Stored Lost Communication DTCs diagnostic procedure.

2. CHECK FOR ANY OF THE FOLLOWING ACTIVE DTCS
1. With the scan tool, read active DTCs from all modules.

NOTE: Check for TIPM configuration, CAN B or C hardware electrical, VIN Missing/Mismatch, battery or ignition related DTCs.

Does the scan tool display any active DTCs to the conditions listed above?

Yes
- Perform the appropriate diagnostic procedure.

No
- Go To 3

3. VERIFY THE HSM IS ACTIVE ON THE BUS
1. Turn the ignition on.
2. With the scan tool, view all the modules.
3. Verify the HSM is active on the bus.

Is the HSM active on the bus?

Yes
- Go To 4

No
- No Response From HSM (Heated Seat Module) and perform the No Response from HSM diagnostic procedure.

4. CHECK FOR ADDITIONAL COMMUNICATION RELATED DTCS
1. With the scan tool, view all the modules.

Is there more than one module with active DTCs "Logged Against" the HSM?

Yes
- Replace/update the Heated Seat Module. .
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No
- Replace/update the module that set this DTC.
- Perform the appropriate verification test.