Body Verification Test

BODY VERIFICATION TEST
Perform Body Verification Test
1. Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
2. Ensure that all accessories are turned off.
3. Ensure that the battery is fully charged.
4. If the TIPM has been replaced, the Pinion Factor MUST be programmed into the TIPM. Refer to the scan tool for program procedure.
5. Turn the ignition on.
6. With the scan tool, record and erase DTCs from all modules (run a vehicle scan report to have as reference).
7. (Export only) If the Intrusion Transceiver Module (ITM) and/or Siren was replaced, select ITM from the from the scan tool menu then "Misc. Functions" Perform the applicable replacement procedure.
8. If the vehicle is equipped with Express Up Power Windows and the battery was disconnected during repairs, run both front windows all the way down. Next, run the window all the way up and hold the switch in the up position for five seconds to re-initialize the express up feature.
9. Turn the ignition off, wait 10 seconds, and then turn the ignition on.
10. Operate all functions of the system that caused the original concern. If a repair or module replacement was done to the power windows, operate the motor fully down and then to the full up position and stall it for 2 seconds.
11. With the scan tool, read all the DTCs in the modules.

Are DTCs present in any of the modules or is the original condition still present?

Yes

- The repair is not complete. Perform the appropriate DTC diagnostic procedure.

No

- The repair is complete.