Passive Entry Module (PEM)

B223B-00-VEHICLE CONFIGURATION MISMATCH

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Whenever a Passive Entry or Keyless Start event is actuated.

- Set Condition:
When a Passive Entry or Keyless Start event is actuated and the PEM receives an incorrect configuration message, it will set this code after three activated events.

- NOTE: Do not attempt to swap PEM modules. If a PEM module has been used on one vehicle, it cannot be used on another vehicle.





1. CHECK MODULE CONFIGURATION

NOTE: If there are any PEM handle or antenna DTCs, perform the diagnostic procedure for them before continuing.

NOTE: Make sure the battery is fully charged.

1. Using the Push Button, turn the ignition on.
2. Using the scan tool, record and erase the DTCs.
3. Using the Push Button, cycle the ignition three times waiting two seconds between cycles.
4. Turn the ignition on.
5. With the scan tool, check the active PEM DTCs.

Does the scan tool display: B223B-00-VEHICLE CONFIGURATION MISMATCH as active?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. CHECK MODULE CONFIGURATION
1. With the scan tool, select: PEM, "Reports", "Configuration Report", "PEM".
2. Record the Vehicle Line and the Driver (side) (LHD/RHD) reported by the PEM.
3. Select "Configuration Report", "TIPM".

Does the configuration report for PEM match the TIPM report?

Yes

- Replace the Passive Entry Module. Passive Entry Module - Removal.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 3

3. TIPM CONFIGURATION
1. Look over the vehicle and check the Vehicle Line and the Driver (side) (LHD/RHD).
2. Compare the PEM configuration report to the actual vehicle (Vehicle line & Drivers side).

Does the PEM configuration report match the actual vehicle?

Yes

- With the scan tool, check the TIPM for any Vehicle Configuration DTCs.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Passive Entry Module. Passive Entry Module - Removal.
- Perform the BODY VERIFICATION TEST. Body Verification Test.