Radio/Stereo: Description and Operation

DESCRIPTION

The radio features have been incorporated into the Telematics Gateway Module. Interaction with the radio features is done through the ISC screen module and switch bank located in the center stack of the instrument panel. For more information Telematics Gateway Module - Description and Instrument Cluster Switch Pod - Description.

RADIO ANTI-THEFT CODE PROCEDURE
For the vehicles that are equipped with power net or NTG4 radios. If the TGM or the radio have been removed or replaced. A four digit security code is required in order for the radio to function:

1. The key must be in the "RUN" position.
2. Press the "ON/VOL" control button.
3. The word "CODE" or " Please enter Anti-Theft Code" will appear on the display.
4. Enter the 4-digit code by pressing the corresponding preset buttons in sequence.

NOTE: If three consecutive attempts are made to enter an invalid anti-theft code the radio will enter a 'WAIT' state. While in this state the radio display will read 'WAIT'. To exit the 'WAIT' state the radio must remain powered with the ignition in the run position for a continuous 30 minutes (the vehicle may be driven during this time). After exiting the 'WAIT' state the radio will again display 'CODE' and a valid anti-theft code may be entered.