Center Floor Console

CENTER FLOOR CONSOLE

AUTOMATIC TRANSMISSION





1. Position the Low Frequency (LF) antenna (1) to the underside of the console floor shift bracket.
2. Install and tighten the two screws that secure the LF antenna to the underside of the shift bracket. Tighten the screws securely.
3. Position the shift bracket close enough to the floor panel transmission tunnel to access and reconnect the wire harness connector (2) to the connector receptacle for the LF antenna.





4. Engage the alignment pin and the two snap clips at the front of the shift bracket (2) into the holes in the instrument panel center support bracket, then lower the rear of the shift bracket far enough to engage the alignment pin into the hole in the floor panel transmission tunnel (3).
5. Install and tighten the four screws (1) that secure the shift bracket to the tunnel. Tighten the screws to 8 Nm (71 in. lbs.).
6. Reinstall the automatic transmission floor shift assembly onto the shift bracket. Refer to Transaxle for the procedures covering the transaxle model and shifter type found in the vehicle.
7. Reconnect the battery negative cable.

MANUAL TRANSMISSION





1. Position the Low Frequency (LF) antenna (2) to the underside of the console floor shift bracket.
2. Install and tighten the two screws that secure the LF antenna to the underside of the shift bracket. Tighten the screws securely.
3. Position the shift bracket close enough to the floor panel transmission tunnel to access and reconnect the wire harness connector (1) to the connector receptacle for the LF antenna.





4. Engage the alignment pin and the two snap clips at the front of the shift bracket (1) into the holes in the instrument panel center support bracket, then lower the rear of the shift bracket far enough to engage the alignment pin into the hole in the floor panel transmission tunnel (4).
5. Position the ground strap (2) to the shift bracket mounting hole.
6. Install and tighten the four screws (3) that secure the shift bracket to the tunnel. Tighten the screws to 8 Nm (71 in. lbs.).
7. Reinstall the manual transmission floor shift assembly onto the shift bracket. Refer to Transaxle for the procedures covering the transaxle model and shifter type found in the vehicle.
8. Reconnect the battery negative cable.