Light Emitting Diode Unit

LIGHT EMITTING DIODE UNIT

NOTE: Each Light Emitting Diode (LED) dome/reading lamp contains two articulating eyeball-type LED pod units with integral lens-actuated switches and printed circuit boards that are available for separate service replacement. The rear LED dome/reading lamp also has a fixed auxiliary LED and printed circuit board unit which is also available for separate service replacement.

ARTICULATED EYEBALL POD UNIT





1. On rear LED dome/reading lamp units only, from the top of the lamp housing, reconnect the pod pigtail wire connector to the fixed auxiliary LED lamp printed circuit board in the center of the lamp.
2. Align the LED lamp pod (1) with the receptacle within the dome/reading lamp housing.
3. Engage the pivot pin on one side of the pod with the pivot socket on one side of the pod receptacle.
4. Using a trim stick or another suitable wide flat-bladed tool, gently pry the receptacle outward far enough to engage the pivot pin on the other side of the pod with the other pivot socket.
5. Using a trim stick or equivalent, flex the housing at point (1) and install lamp pod.
6. Reinstall the LED dome/reading lamp unit. . Light Emitting Diode Unit
7. Reconnect the battery negative cable.

FIXED AUXILIARY LED AND CIRCUIT BOARD UNIT





1. Position the auxiliary LED and circuit board unit (4) into the lamp housing.
2. Install and tighten the six screws (2) that secure the printed circuit board to the lamp housing. Tighten the screws securely.
3. Reconnect the lamp wiring to the auxiliary LED wiring connector (3).
4. Reinstall and reconnect (1) the two articulated eyeball LED pods into the lamp housing.
5. Reinstall the rear LED dome/reading lamp unit. . Light Emitting Diode Unit
6. Reconnect the battery negative cable.