Second Row - Outboard

SECOND ROW - OUTBOARD

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.





1. Position the second row outboard seat belt and retractor (5) to the quarter inner panel just below the base of the upper C-pillar (3) as a unit.
2. Engage the tab on the retractor bracket into the keyed hole in the quarter inner panel.
3. Install and tighten the screw (4) that secures the retractor to the quarter inner panel. Tighten the screw to 58 Nm (43 ft. lbs.).
4. Position the web guide (2) to the quarter inner panel near the base of the C-pillar. Be certain the seat belt webbing is not twisted between the retractor and the web guide.
5. Using hand pressure, press firmly and evenly on the web guide to snap it into place.
6. Position the seat belt turning loop to the inside of the upper C-pillar. Be certain the seat belt webbing is not twisted between the web guide and the turning loop.
7. Install and tighten the screw (1) that secures the turning loop to the C-pillar. Tighten the screw to 43 Nm (32 ft. lbs.).
8. Reinstall the upper trim (2) onto the inside of the C-pillar (5). C-Pillar Trim Panel - Installation.





9. Position the lower seat belt (2) anchor to the rear floor panel (3) near the base of the lower C-pillar (1). Be certain the seat belt webbing is not twisted between the turning loop and the lower anchor.
10. Install and tighten the screw (4) that secures the lower seat belt anchor to the floor. Tighten the screw to 58 Nm (43 ft. lbs.).
11. Reinstall the front of the quarter trim panel onto the lower C-pillar. Quarter Trim Panel - Installation.