Second Row - Center

SECOND ROW - CENTER

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.





1. Remove the second row right seat from the vehicle. Seat - Removal.
2. Reach under the rear edge of the second row right seat cushion frame just to the right of the lower end of the inboard center seat back hinge bracket (1) to access the right buckle lower anchor (3) and the center seat belt lower anchor (2).
3. Remove the screw (4) that secures the right buckle lower anchor and the center seat belt lower anchor to the right seat cushion frame.
4. From the front of the second row right seat, pull the center seat belt lower anchor out from between the right seat cushion and back trim covers.





5. Using a trim stick or another suitable wide flat-bladed tool, carefully pry the belt web guide bezel (3) upward from the top of the right seat back (2) far enough to disengage the three barrel clips that secure the bezel to the seat back frame.
6. Slide the center seat belt webbing (1) through the slot in the guide bezel to disengage the belt from the bezel.





7. Remove the head rest, back panel and trim cover from the right seat back frame (1). It is not necessary to remove the seat back frame from the seat cushion frame. Seat Back - Removal.
8. Remove the screws (4) that secure the molded plastic shield (5) to the top of the seat back frame. Pull the top of the seat back foam away from the seat back frame to access the lower screws securing the shield.
9. Remove the molded plastic shield from the top of the seat back frame.
10. From the back side of the seat back frame, remove the screw (2) that secures the retractor (3) to the frame.
11. Lift the retractor upward far enough to disengage the T-tab of the retractor bracket from the keyed slot in the seat back frame.
12. Guide the seat belt webbing through the slot in the top of the seat back frame while removing the seat belt and retractor from the seat as a unit.