Rear Wiper Motor - Removal

REAR





1. Disconnect and isolate the battery negative cable.
2. Remove the rear wiper arm (3) from the rear wiper motor output shaft. . Rear Wiper Arm - Removal

NOTE: The output shaft bezel and grommet (4) does not have to be removed to remove the rear wiper motor from the liftgate.

3. Remove the trim panel from the liftgate inner panel (2). Liftgate Trim Panel - Removal.
4. Disconnect the wire harness connector (7) from the rear wiper motor (1).
5. Remove the three screws (6) that secure the motor mounting bracket to the liftgate inner panel.
6. Remove the motor from the liftgate.
7. Remove the bezel and rubber grommet on the outer liftgate panel from the output shaft clearance hole. Be certain to take proper precautions to protect the outer liftgate panel and its paint finish from damage during this procedure.