Brake Master Cylinder Reservoir - Installation

INSTALLATION

NOTE: The brake fluid level switch is mounted through the center of the fluid reservoir. The switch can be serviced separately from the master cylinder fluid reservoir Brake Fluid Level Switch - Installation





1. Lubricate the reservoir mounting area with fresh clean brake fluid. With the grommet seals (2) on the fluid reservoir spigots, place the reservoir in position over the master cylinder. Install the fluid reservoir by firmly pressing down on the fluid reservoir. Once installed, make sure the fluid reservoir is touching the top of both grommet seals.

2. Push the reservoir retaining tabs over the mounting posts on the master cylinder housing. Make sure the retaining tabs are securely engaged.
3. Fill the brake fluid reservoir with fresh Mopar(R) Brake Fluid DOT 3 Motor Vehicle, or equivalent [1][2]Brake Fluid
4. Install the front wiper motor module Wiper Arm Linkage - Installation
5. Install the inner and outer cowl covers Service and Repair