Tilt Lever Release Knob - Installation

INSTALLATION






NOTE: A new tilt release lever (1) includes a pre-loaded spring (3) and the linkage. The spring will have tension and should not be released prior to installation.

1. If the original tilt release lever (1) is to be reinstalled on the column, carefully reload the spring (3) against the tab (2) as shown.






NOTE: The release lever/cam linkage (3) is tabbed to lock into the release cam (1) after installation.

2. Insert the tilt release lever/cam linkage (3) into the slotted cam hole (2) and rotate the tilt release lever (4) into position.





3. Install the tilt release lever screws (3).





4. From the underside the column, push the pre-loaded spring tip (1) up with a small flat blade screwdriver or suitable tool to release the spring from the tab. The spring should snap against the column in the area shown (3). Verify the tilt release lever for proper operation before proceeding.





5. Position the multi-function switch mounting bracket and install the lower retaining screw (4).
6. If equipped, connect the adjustable pedals switch connector (5), harness routing retainer (2), and SAS connector (3).
7. Connect the clockspring connectors (1).





8. Install the multi-function switch mounting bracket upper retaining screw (2).
9. Install the steering column shrouds, Steering Column Shroud - Installation.
10. Connect the negative battery cable.