Installation

4X4










1. Install the brake dust shield (2).
2. Install the hub/bearing (1) into the steering knuckle (3) and tighten the bolts to specifications .

3. Install the brake rotor and caliper Brake Rotor - Installation.
4. Install the ABS wheel speed sensor if equipped Front.
5. Install the upper ball joint nut to the steering knuckle and tighten to specifications .
6. Install the tie rod end nut to the steering knuckle and tighten to specifications .
7. Install the halfshaft nut and tighten to specifications .
8. Install the wheel and tire assembly Service and Repair.
9. Remove the support and lower vehicle.