B185E-13

B185E-13-PASSENGER WINDOW CONTROL - CIRCUIT OPEN





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Whenever the module is awake.

- Set Condition:
When one or both Driver Window Driver circuits (Up and Down) are not supplied with voltage, when they should be, during a window movement command for more than 2000 ms.





1. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. Operate the Passenger Window switch up and down several times.
4. Wait 30 seconds.
5. With the scan tool, read the active DTCs.

Does the scan tool display B185E-13-PASSENGER WINDOW CONTROL - CIRCUIT OPEN?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. WINDOW MOTOR OR CIRCUIT OPEN




1. Turn the ignition off.
2. Disconnect the Passenger Window Motor harness connector.
3. Connect a test light between the (Q12) Passenger Window Driver (Up) circuit and the (Q22) Passenger Window Driver (Down) circuit.
4. Turn the ignition on.
5. Trip the driver door latch to the closed position.
6. Operate the Passenger Window switch up and down several times while observing the test light.

Does the test light illuminate brightly when the switch is pressed in both directions? With the express up window, the test light will only flash momentarily each time the switch is activated.

Yes

- Replace the Passenger Window Motor (regulator).
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 3

3. (Q22) PASSENGER WINDOW DRIVER (DOWN) CIRCUIT OPEN




1. Turn the ignition off.
2. Disconnect the Passenger Door Module C4 harness connector.
3. Measure the resistance of the (Q22) Passenger Window Driver (Down) circuit between the Passenger Door Module C4 module harness connector and the Passenger Window Motor harness connector.

Is the resistance above 2.0 Ohms?

Yes

- Repair the open in the (Q22) Passenger Window Driver (Down) circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 4

4. (Q12) PASSENGER WINDOW DRIVER (UP) CIRCUIT OPEN




1. Measure the resistance of the (Q12) Passenger Window Driver (Up) circuit between the Passenger Door Module C4 module harness connector and the Passenger Window Motor harness connector.

Is the resistance above 2.0 Ohms?

Yes

- Repair the open in the (Q12) Passenger Window Driver (Up) circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

Yes

- Replace the Passenger Door Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.