Final Drive Control Module (FDCM)

C2101-BATTERY VOLTAGE HIGH





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously.

- Set Condition:
The Final Drive Control Module (FDCM) detects that system voltage is above 16.0 volts for 10 seconds with engine RPM greater than 350.





1. CHARGING SYSTEM DTCs PRESENT
1. Ignition on, engine not running.
2. With the scan tool, read DTCs.

Are there any Charging System or related voltage DTCs present?

Yes

- Perform the appropriate Charging System DTC diagnostic procedures before continuing with this test Testing and Inspection.

No

- Go To 2

2. DTC IS ACTIVE
1. With the scan tool, read DTCs.

Is the status Active for this DTC?

Yes

- Go To 3

No

- Go To 5

3. FINAL DRIVE CONTROL MODULE (FDCM) GROUND CIRCUITS OPEN OR HIGH RESISTANCE




1. Turn the ignition off.
2. Disconnect the FDCM harness connector.
3. Ignition on, engine not running.
4. With a 12-volt test light connected to B+, check the (Z935) Ground circuits in the FDCM harness connector.

NOTE: The test light must illuminate brightly. Compare the brightness to that of a direct connection to the battery.

Does the test light illuminate brightly for each of the Ground circuits?

Yes

- Go To 4

No

- Repair the (Z935) Ground circuit(s) for an open circuit or high resistance.
- Perform the FDCM VERIFICATION TEST. FDCM Verification Test.

4. FINAL DRIVE CONTROL MODULE (FDCM)

View the repair.

Repair

- Replace the Final Drive Control Module (FDCM).
- Perform the FDCM VERIFICATION TEST. FDCM Verification Test.

5. INTERMITTENT WIRING AND CONNECTORS
1. The conditions necessary to set this DTC are not present at this time.
2. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
3. While monitoring the scan tool data relative to this circuit, wiggle test the wiring and connectors.
4. Look for the data to change or for the DTC to reset during the wiggle test.

Were any problems found?

Yes

- Repair as necessary.
- Perform the FDCM VERIFICATION TEST. FDCM Verification Test.

No

- Test complete.