Front Door: Adjustments

ADJUSTMENTS

NOTE: For quad cab vehicles, it is recommended that you adjust the rear door before adjusting the front door. Adjustments
- Door adjustment measurements should be taken from stationary or welded body panels like the roof, rocker or quarter panels.
- During adjustment procedures, it is recommended that all the hinge fasteners be loosened except for the upper most fasteners. Adjustments can be made using the upper bolts to hold the door with final torque of the fasteners occurring after correct door positioning is achieved.
- A suitable body sealant should be used when removing or moving the hinges.

FORE/AFT





NOTE: Fore/aft (lateral) door adjustment is done by loosening the hinge to the hinge pillar fasteners one hinge at a time and moving the door to the correct position.

1. Support the door with a suitable lifting device.
2. Loosen the upper and lower hinge to hinge pillar fasteners (2). Front Door Hinge - Removal
3. Adjust the door to the correct position.
4. Tighten the hinge to hinge pillar bolts (2) to 24 Nm (18 ft. lbs.).

UP/DOWN





NOTE: Up/down door adjustment is done by loosening either the hinge to the hinge pillar fasteners or the hinge to door fasteners and moving the door to the correct position.

NOTE: When the up/down adjustments are done correctly, the top of the door is positioned over flush to the roof.

1. Support the door with a suitable lifting device.
2. Remove the latch striker (1). Door Latch Striker - Removal





3. If necessary, loosen the hinge to door fasteners (1) and (3). Front Door - Removal





4. If necessary, loosen the hinge to hinge pillar fasteners (2). Front Door Hinge - Removal
5. Adjust the door to the correct position.





6. Tighten the door to hinge fasteners to 22 Nm (16 ft. lbs.)





7. Tighten the hinge to hinge pillar bolts (2) to 24 Nm (18 ft. lbs.).





8. Install the latch striker(1). Door Latch Striker - Installation

IN/OUT





NOTE: In/out door adjustment is done by loosening the hinge to door fasteners one hinge at a time and moving the door to the correct position.

NOTE: When adjustment of the door requires the loosening of the door to hinge fasteners, it will be necessary to separate the epoxy bonded washers with a chisel or other suitable tool.

1. Support the door with a suitable lifting device.
2. Remove the latch striker (1). Door Latch Striker - Removal





3. Loosen the hinge to door fasteners. Front Door - Removal
4. Adjust the door to the correct position.
5. Tighten the door to hinge fasteners to 22 Nm (16 ft. lbs.).





6. Install the latch striker (1). Door Latch Striker - Installation