Fuel Pump Module - Removal

REMOVAL

Special Tools:











WARNING: The fuel system may be under a constant pressure (even with the engine off). Before servicing the fuel pump module, the fuel system pressure must be released.

1. Perform the fuel system pressure release procedure Service and Repair
2. Disconnect and isolate the negative battery cable (1).
3. Remove the fuel tank Fuel Tank - Removal






NOTE: Prior to removing the fuel pump module, use compressed air to remove any accumulated dirt and debris from around fuel tank opening.

CAUTION: An indexing arrow is located on top of the main fuel pump module to clock it's position into the fuel tank, note it's location for reassembly.

4. Position the lock ring remover/installer (3) into the notches on the outside edge of the lock ring (5).
5. Install a 1/2 inch drive breaker bar (1) into the lock ring remover/installer (3).
6. Rotate the breaker bar counterclockwise and remove the lock ring.

CAUTION: Whenever the fuel pump module is serviced, the rubber O-ring seal must be replaced.

7. Remove the fuel pump module (4) from the fuel tank. Be careful not to bend float arm during removal.
8. Remove and discard the rubber O-ring seal.