Fog Lamp - Installation

LAMP

EXCEPT SPORT

NOTE: The fog lamps are secured within one of two mounting brackets. One bracket is secured to the bumper or fascia with two mounting screws and the other by three mounting screws. Other than the number of mounting screws, the two lamps are identical.




Figure 1 - Two Mounting Screws



Figure 2 - Three Mounting Screws

NOTE: The front fog lamp, the fog lamp mounting bracket and the fog lamp adjuster are serviced only as a complete unit. Only the fog lamp bulb is available for separate service replacement.

1. Position the fog lamp and mounting bracket (1) to the back of the front bumper as a unit.
2. Install and tighten the two or three screws (4) that secure the fog lamp and mounting bracket to the back of the front bumper. Tighten the screws to 8 Nm (71 in. lbs.).
3. Reconnect the fog lamp jumper wire harness (3) connector to the fog lamp bulb (2) connector receptacle.
4. Lower the vehicle.
5. Reconnect the battery negative cable.
6. Confirm proper fog lamp alignment. Adjustments.

SPORT





NOTE: The front fog lamp, the fog lamp mounting bracket and the fog lamp adjuster are serviced only as a complete unit. Only the fog lamp bulb is available for separate service replacement. On Sport models the fog lamp mounting bracket is not used. The mounting bracket of the service replacement fog lamp is removed from the fog lamp and discarded, then the fog lamp is mounted directly to the front energy absorber.

1. Position the fog lamp (2) and retainer grommets (4) as a unit to the fog lamp seat on the face of the front energy absorber (1).
2. Align the three fog lamp retainer grommets with the mounting holes in the fog lamp seat of the front energy absorber.
3. Using hand pressure, press firmly and evenly on the fog lamp lens until the legs of all three grommet retainers snap into place on the back side of the front energy absorber.
4. Reconnect the fog lamp jumper wire harness connector (3) to the fog lamp bulb connector receptacle.
5. Lower the vehicle.
6. Reinstall the front fascia over the face of the front energy absorber. Front Bumper Fascia - Installation.
7. Reconnect the battery negative cable.
8. Confirm proper fog lamp alignment. Adjustments.