Tail Stop Turn Lamp - Removal

LAMP - CAB AND CHASSIS





1. Disconnect and isolate the battery negative cable.
2. Disconnect the rear lamp unit pigtail wire connector (2) from the chassis wire harness connector for the rear lamp at the back of the rear frame crossmember (1).
3. Disengage the rear lamp unit pigtail wire and connector from the rear frame rail.
4. Remove the two nuts (6) that secure the studs on the rear lamp unit housing (3) to the lamp mounting bracket (5) on the rear frame rail.
5. For the left side lamp only, remove the license plate mounting bracket (4) from the rear lamp unit studs.
6. Remove the rear lamp unit from the mounting bracket while feeding the pigtail wire and connector through the bracket.