Front Parking Brake Cable - Installation - RHD

FRONT CABLE - RIGHT-HAND-DRIVE






1. Pass most of the front parking brake cable (5) down through the access hole in the floor pan (4) from inside the vehicle.





2. Insert the lever end of the front parking brake cable through the mounting hole in the floor mounted bracket (4). Slide it through until the retainer fingers on the end of the housing lock in place. Make sure all the fingers are engaged preventing removal of the cable from the bracket.

3. Pull the button on end of front parking brake cable strand (3) out of housing, then rotate it around and slide the button into place, attaching the cable to the lever mechanism.

4. Slide any extra cable back into the cable housing.

5. Insert the front parking brake cable floor pan seal into the hole in the floor pan.

6. Raise and support the vehicle.





7. Pass the end of the front cable (5) through the hole in the end of the intermediate bracket (1). Press the cable housing retainer through the hole until the fingers on the retainer lock it into place.

8. Attach the front cable to the routing clips fastened to the underbody of the vehicle.

9. Attach the equalizer to the three parking brake cables and reset the automatic adjuster tension on the cables. Service and Repair

10. Lower the vehicle.

11. Apply and release park brake pedal one time. This will seat the parking brake cables and allow the automatic adjuster in the parking brake lever mechanism to correctly tension the parking brake cables.





12. Install the floor mounted console (3). Floor Console - Installation

13. Check operation of parking brakes.