Front Evaporator Temperature Sensor - Removal

REMOVAL

WARNING:
Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE:
LHD model shown. RHD model similar.





1. Disconnect and isolate the negative battery cable.

2. On LHD models, remove the right side instrument panel silencer.

3. On RHD models, remove the driver side knee blocker.

4. Disconnect the wire harness connector (2) from the evaporator temperature sensor (3) located on the right side of the HVAC housing (1).

5. Remove the evaporator temperature sensor from the HVAC housing.