Electronic Vehicle Information Center Switch - Installation - RHD

INSTALLATION - RHD

WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Position the steering wheel switch onto the switch bezel aligning the switch tabs (1) with the bezel retainers (2).

2. Press the switch into the bezel until the switch is held in place by all four retainers.





3. Position the switch and bezel assembly (3) over the steering wheel and connect the switch electrical connector.

4. Align the switch bezel tab (1) with the slot in the steering wheel and press the switch and bezel assembly (3) into the steering wheel until it is secured in place.

5. Install the driver airbag, Driver Air Bag - Installation.

6. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed following service of any SRS component. Restraint System Verification Test.

7. Connect the battery negative cable.