Headlamp Washer Pump Motor - Installation - Export

INSTALLATION

1. Use new grommet when installing a new pump assembly.

2. Assure pump upper retention tab is pressed into reservoir slot and assure the pump is aligned to and fully seated in the reservoir cavity.

3. Push filler neck and front washer hose through the opening in the front fender side shield. Connect the reservoir to the body mount by lowering the reservoir down.

4. Install the two reservoir mounting screws. Tighten screws to 8.5 - 11.3 Nm (75 - 100 in. lbs.).

5. Connect the electrical body harness connectors to the washer pump motors and the fluid level sensor. Slide the red lock on the connector to the closed or locked position.

6. Connect front and rear washer pump hoses and assure that they are properly routed to prevent pinching and possible inoperative washers.

7. Connect the high pressure headlamp washer hose by firmly pushing hose onto inlet until a snap is heard.

8. Connect the right front wheelhouse splash shield and move aside. Splash Shield - Installation.

9. Install the right front wheel and tire assembly Tires And Wheels - Installation.

10. lower vehicle from hoist or jack stands.

11. Connect the washer hose at the in-line on top of reservoir.

12. Install the engine fresh air housing inside the engine compartment. Air Cleaner Body - Installation.

13. Connect the battery negative cable.

14. Verify vehicle and system operation.