Headlamp Washer Pump Motor - Removal - Export

REMOVAL

1. Disconnect and isolate the battery negative cable.

2. Remove the engine fresh air housing inside the engine compartment. Air Cleaner Body - Removal.

3. Disconnect the washer hose at the in-line connector on top of reservoir.

4. Hoist and support vehicle on hoist or jack stands.

5. Remove the right front wheel and tire assembly. Tires And Wheels - Removal.

6. Disconnect the right front wheelhouse splash shield and move aside. Splash Shield - Removal.

7. Drain washer fluid from the reservoir and into a suitable clean container. This can be done by disconnecting the windshield washer hose from the front (outboard) washer pump and allowing the washer fluid to drain into a container through a temporary jumper hose connected to the front washer pump.

8. Disconnect the rear washer pump hose from washer pump.

9. Disconnect the high pressure headlamp washer pump hose by pressing down firmly on latch and pulling hose off.

10. Disconnect the electrical body harness connectors to the washer pump motors and the fluid level sensor. Slide the red lock on the connector to the release position, then, depress the black tab and pull the connector off the pump or sensor.

11. Remove the two reservoir mounting screws.

12. Disconnect the reservoir from the body mount by raising the reservoir upward slightly and then down so that the reservoir filler neck and front washer hose pull through the opening in the front fender side shield.

13. Remove pump from reservoir by pulling pump up and away from reservoir cavity and out of mounting grommet. Do not damage reservoir/pump sealing surface or puncture reservoir during removal.

14. Remove pump grommet and discard.